Get premium membership and access questions with answers, video lessons as well as revision papers.
To increase the conductivity of a semi-conductor
sharon kalunda answered the question on April 5, 2019 at 12:37
- Figure below shows a diagram of an n – p – n transistor.(Solved)
Figure below shows a diagram of an n – p – n transistor.
Complete the diagram by showing the connections of two batteries suitable for biasing the
transistor in the common- emitter mode.
Date posted: April 5, 2019. Answers (1)
- Three identical bulbs are connected in series with a battery of dry cells. At first the bulbs
shine brightly but gradually become dimmer. Using the same...(Solved)
Three identical bulbs are connected in series with a battery of dry cells. At first the bulbs
shine brightly but gradually become dimmer. Using the same cells, explain how you
would increase the brilliance of the bulbs
Date posted: April 5, 2019. Answers (1)
- A girl opened up a used up dry cell and found the following:
i) The zinc casing was ‘eaten away’
ii) The cell was watery(Solved)
A girl opened up a used up dry cell and found the following:
i) The zinc casing was ‘eaten away’
ii) The cell was watery
Name the cell defect
Date posted: April 5, 2019. Answers (1)
- State one reason why colour televisions have a higher power rating than black and white
televisions(Solved)
State one reason why colour televisions have a higher power rating than black and white
televisions
Date posted: April 5, 2019. Answers (1)
- The figure shows a simple cell made of copper and zinc electrodes dipped in dilute
sulphuric acid(Solved)
The figure shows a simple cell made of copper and zinc electrodes dipped in dilute
sulphuric acid.
a) Identify the cathode
b) If a voltmeter is connected across the rods the reading is observed to reduce with time.
State two causes of this observation
Date posted: April 5, 2019. Answers (1)
- The figure below shows the set up for a simple cell.(Solved)
The figure below shows the set up for a simple cell.
a) Name the Electrode A and the solution B
b) State two reasons why the bulb goes off after a short time
Date posted: April 5, 2019. Answers (1)
- Distinguish between Topping and Dopping(Solved)
Distinguish between Topping and Dopping
Date posted: April 5, 2019. Answers (1)
- Figure shows a voltmeter connected across the cell. The voltmeter reads 1.5V when the
switch S, is open and 1.25V when the switch is closed.(Solved)
Figure shows a voltmeter connected across the cell. The voltmeter reads 1.5V when the
switch S, is open and 1.25V when the switch is closed.
i) What is the e.m.f of the cell?
ii) What is the terminal voltage of the cell?
iii) Calculate the internal resistance of the cell
Date posted: April 5, 2019. Answers (1)
- Distinguish between a p- type and an n- type extrinsic semiconductors(Solved)
Distinguish between a p- type and an n- type extrinsic semiconductors
Date posted: April 5, 2019. Answers (1)
- Explain why eight 1.5V cells arranged in series to give a total of 12V cannot be used to start
a car. But car battery of 12V...(Solved)
Explain why eight 1.5V cells arranged in series to give a total of 12V cannot be used to start
a car. But car battery of 12V starts a car
Date posted: April 5, 2019. Answers (1)
- Figure below shows a circle with two diodes P and Q and a cell:-(Solved)
Figure below shows a circle with two diodes P and Q and a cell:-
Explain the observation which would be made if S is closed
Date posted: April 5, 2019. Answers (1)
- With the time base switched on; the following trace was obtained on the screen of a CRO as
shown in the figure below:(Solved)
With the time base switched on; the following trace was obtained on the screen of a CRO as
shown in the figure below:
Draw a circuit diagram that can be used to produce the wave above
Date posted: April 5, 2019. Answers (1)
- Explain how conductivity of a semiconductor changes with increase in temperature(Solved)
Explain how conductivity of a semiconductor changes with increase in temperature
Date posted: April 5, 2019. Answers (1)
- The figure below shows a circuit diagram for full wave rectification(Solved)
The figure below shows a circuit diagram for full wave rectification
Draw the diodes D3 and D4 on the diagram to complete the circuit
Date posted: April 5, 2019. Answers (1)
- The diagram below shows a simple cell:-(Solved)
The diagram below shows a simple cell:-
(i) Name z and solution y
(ii) Name and explain the defect that occurs at plate z
(iii) Give one method of preventing the defect that occurs at the copper plate
Date posted: April 5, 2019. Answers (1)
- A household uses a 1.5Kw water heater for 2 hours a day for 30 days. If the cost of
electricity is shs.6.70 per Kwh, how much...(Solved)
A household uses a 1.5Kw water heater for 2 hours a day for 30 days. If the cost of
electricity is shs.6.70 per Kwh, how much will they pay for this consumption?
Date posted: April 5, 2019. Answers (1)
- The diagram below shows a wrongly wired three pin plug.(Solved)
The diagram below shows a wrongly wired three pin plug.
(i) Indicate in the diagram above the correct colors for the wiring
(ii) State the use of device marked X
Date posted: April 5, 2019. Answers (1)
- Aluminium wires are commonly used in power transmission than copper wires. Give two
advantages of aluminum as transmission lines(Solved)
Aluminium wires are commonly used in power transmission than copper wires. Give two
advantages of aluminum as transmission lines
Date posted: April 5, 2019. Answers (1)
- State the advantage of transmitting power at Alternating voltage.(Solved)
State the advantage of transmitting power at Alternating voltage.
Date posted: April 5, 2019. Answers (1)
- State the advantage of transmitting power at Very high voltage(Solved)
State the advantage of transmitting power at Very high voltage
Date posted: April 5, 2019. Answers (1)