- The figure shows three resistors as shown.If the voltmeter reads 4V, find the(Solved)
The figure shows three resistors as shown.If the voltmeter reads 4V, find the
(i) Effective resistance
(ii) Current through the 3 ohms resistor
(iii) Potential difference across the 8 ohms resistor.
Date posted: September 6, 2019. Answers (1)
- Define electric resistance.(Solved)
Define electric resistance.
Date posted: September 6, 2019. Answers (1)
- Light of frequency 5.50 x 1014 Hz is incident on a surface whose work function is 2.5ev.
(i) Determine the energy of photons of light in...(Solved)
Light of frequency 5.50 x 1014 Hz is incident on a surface whose work function is 2.5ev.
(i) Determine the energy of photons of light in eV. (Take h = 6.63 x 10-34 Js) and 1eV
(ii) Will photoelectric emission occur? Explain
Date posted: September 6, 2019. Answers (1)
- The figure below shows photocell used in a set-up for a burglar alarm.(Solved)
The figure below shows photocell used in a set-up for a burglar alarm.
(i) Give a reason why the photocell is usually evacuated.
(ii) State the function of the resistor R in this circuit
(iii) Explain why a particular radiation such as ultra-violet light is used to strike a given cathode surface.
(iv) Explain how the set-up in the figure can be used as a burglar alarm.
Date posted: September 6, 2019. Answers (1)
- The figure below illustrates a method of charging a metal sphere.(Solved)
The figure below illustrates a method of charging a metal sphere.
(i) Name the method of charging shown in the figure.
(ii) Indicate the final charge on the sphere in the figure.
Date posted: September 6, 2019. Answers (1)
- In an experiment to investigate factors affecting capacitance of a capacitor, a student increased the area of the plates and decreased the separation of the...(Solved)
In an experiment to investigate factors affecting capacitance of a capacitor, a student increased the area of the plates and decreased the separation of the plates. Explain the effect on the capacitance when
(i) the area of plates increased
(ii) the distance of the separation of the plates decreased
Date posted: September 6, 2019. Answers (1)
- A converging lens forms an image which is three times the object. Determine the focal length of the lens if the distance between the object...(Solved)
A converging lens forms an image which is three times the object. Determine the focal length of the lens if the distance between the object and the screen is 80cm.
Date posted: September 6, 2019. Answers (1)
- The graph below shows the variation of 1/v and 1/u in an experiment to determine the focal length of a lens.(Solved)
The graph below shows the variation of 1/v and 1/u in an experiment to determine the focal length of a lens.
(i) Use the graph to determine the focal length
(ii) What is the power of the lens used?
Date posted: September 6, 2019. Answers (1)
- An optician in Eldoret Hospital examined an eye of a patient and made the following observations:
Eye too short and the focal length of the eye...(Solved)
An optician in Eldoret Hospital examined an eye of a patient and made the following observations:
Eye too short and the focal length of the eye lens short
(i) State the eye defect the patient could be having.
(ii) Use a diagram to describe how the defect could be corrected.
Date posted: September 6, 2019. Answers (1)
- Some students wish to determine the focal length of a convex lens of thickness 0.6cm using an optical pin and a plane mirror.The figure shows...(Solved)
Some students wish to determine the focal length of a convex lens of thickness 0.6cm using an optical pin and a plane mirror.The figure shows the experimental set up when there is no parallax between the pin and the image.
Determine the focal length of the lens.
Date posted: September 6, 2019. Answers (1)
- Below is part of a circuit that was setup by form four students of Okok Seconday School during a physics practical lesson to demonstrate full...(Solved)
Below is part of a circuit that was setup by form four students of Okok Seconday School during a physics practical lesson to demonstrate full wave rectification using two diodes. Complete the circuit by correctly placing the load R and two diodes.
Date posted: September 6, 2019. Answers (1)
- A sample of a radioactive substance initially has 8.0 x 1025 particles. The half life of the sample is 98 seconds. Determine the number of...(Solved)
A sample of a radioactive substance initially has 8.0 x 1025 particles. The half life of the sample is 98 seconds. Determine the number of particles that will remain after 294 seconds.
Date posted: September 6, 2019. Answers (1)
- A form two student from Kimomo Secondary School found his dry cells leaking on removing from his torch. What would be the possible cause of...(Solved)
A form two student from Kimomo Secondary School found his dry cells leaking on removing from his torch. What would be the possible cause of the leakage?
Date posted: September 6, 2019. Answers (1)
- A vibrator is sending out 8 ripples per second across a ripple water tank. The ripples are observed to be 4cm apart. Calculate the velocity...(Solved)
A vibrator is sending out 8 ripples per second across a ripple water tank. The ripples are observed to be 4cm apart. Calculate the velocity of the ripples
Date posted: September 6, 2019. Answers (1)
- One of the factors that affect efficiency of a transformer is hysteresis losses. What is hyteresis losses?(Solved)
One of the factors that affect efficiency of a transformer is hysteresis losses. What is hyteresis losses?
Date posted: September 6, 2019. Answers (1)
- Give a reason why x-rays but not radio waves are used to detect fractured bones.(Solved)
Give a reason why x-rays but not radio waves are used to detect fractured bones.
Date posted: September 6, 2019. Answers (1)
- The following figure shows the path of a ray of light through a transparent material placed in air.(Solved)
The following figure shows the path of a ray of light through a transparent material placed in air.
Determine the refractive index of the transparent material
Date posted: September 6, 2019. Answers (1)
- The control grid in a cathode ray oscilloscope (CRO) is used to control the brightness of the beam on the screen. Explain how the brightness...(Solved)
The control grid in a cathode ray oscilloscope (CRO) is used to control the brightness of the beam on the screen. Explain how the brightness of the beam can be increased.
Date posted: September 6, 2019. Answers (1)
- A current of 0.7A flows through a wire when a potential difference of 0.35V is applied at the ends of the wire. If the wire...(Solved)
A current of 0.7A flows through a wire when a potential difference of 0.35V is applied at the ends of the wire. If the wire is 0.5m long and has a cross-sectional area of 8.0 x 103mm2, determine its resistivity.
Date posted: September 6, 2019. Answers (1)
- The figure below shows a positively charged metal plate with an earthing connection. State and explain the final charge of the plate.(Solved)
The figure below shows a positively charged metal plate with an earthing connection. State and explain the final charge of the plate.
Date posted: September 6, 2019. Answers (1)