Get premium membership and access questions with answers, video lessons as well as revision papers.
-pass through all materials.
-move from north to south outside magnet.
-those moving same direction repel.
-form complete loops.
marto answered the question on September 18, 2019 at 07:41
- List four layout tools used in metal fabrication.(Solved)
List four layout tools used in metal fabrication.
Date posted: September 18, 2019. Answers (1)
- Name the materials used to make the following parts of ac machine in Table 1 and in each case state one reason why the material...(Solved)
Name the materials used to make the following parts of ac machine in Table 1 and in each case state one reason why the material is used.
b) State three factors to consider when choosing motor for a particular installation.
Date posted: September 18, 2019. Answers (1)
- Sketch and label the schematic diagram of a dc shunt motor connected to a supply.(Solved)
Sketch and label the schematic diagram of a dc shunt motor connected to a supply.
Date posted: September 18, 2019. Answers (1)
- Three capacitors are connected as shown in Figure 1.(Solved)
Three capacitors are connected as shown in Figure 1.
Figure 1
Calculate:
i. The equivalent capacitance
ii. Charge stored in the 26μF capacitor
Date posted: September 18, 2019. Answers (1)
- After installing new cells in a 2 cell torch it failed to light when switched on. State two possible causes for the failure.(Solved)
After installing new cells in a 2 cell torch it failed to light when switched on. State two possible causes for the failure.
Date posted: September 18, 2019. Answers (1)
- State two reasons why the rotating field alternator is preferred to the rotating armature type.(Solved)
State two reasons why the rotating field alternator is preferred to the rotating armature type.
Date posted: September 18, 2019. Answers (1)
- a)The range of a moving iron instrument of resistance 8 ohms is extended by using a shunt resistor of 0.04 ohm. If the full scale...(Solved)
a)The range of a moving iron instrument of resistance 8 ohms is extended by using a shunt resistor of 0.04 ohm. If the full scale deflection current is 10mA, determine the maximum current that the modified instrument can measure.
b) State two advantages and two disadvantages of the moving iron instrument over moving coil instrument
Date posted: September 18, 2019. Answers (1)
- State the role of Directorate of Industrial Training.(Solved)
State the role of Directorate of Industrial Training.
Date posted: September 18, 2019. Answers (1)
- List two safety precautions taken while drilling through a piece of sheet metal.(Solved)
List two safety precautions taken while drilling through a piece of sheet metal.
Date posted: September 18, 2019. Answers (1)
- State the most immediate action to be taken when rescuing a worker found unconscious and still in contact with a live wire.(Solved)
State the most immediate action to be taken when rescuing a worker found unconscious and still in contact with a live wire.
Date posted: September 18, 2019. Answers (1)